Service Stabilitrak Chevy Cruze Issue and Its Repairmen Cost

Services Stabilitrak Chevy Cruze is one of the most frequently encountered problems in this particular model as well as other models made by GM. StabiliTrak is the trademarked method by GM that offers stability to the car. It is a system that alerts when the vehicle cannot be supported because of the observed lack of the lateral StabiliTrak.

The message could mean one of the following that indicate a problem within the system, or the system is not functioning or the system detects an insufficient signal. If the light for the traction control system in your Cruze is illuminated also, the issue will most likely be related to the system.

When the light illuminated during your drive and continues to show then there's a good possibility that you should take your vehicle to a service center. Note that once the warning light comes to on, your system has been shut down , and it is unable to control wheel spins, therefore you must be careful when driving.

What triggers this Service Stabilitrak Chevy Cruze light to come on however? It happens when the sensor for wheel speed is able to detect one that rotates at a greater speed than the other wheels and causes the car to lose its grip or slide away. When this happens the system isn't capable of assisting you in controlling the traction. In the absence of traction control, your car could slide or roll off the road.

If you find no issue then you can disable your service Stabilitrak and the traction control Chevy Cruze. Just press the button of StabiliTrak for a couple of minutes. Then , turn your steering wheel the clockwise direction. If this action causes the warning light to stop and your car doesn't need any assistance. If the warning signal continues to flash make sure you shut off your vehicle, wait for a few minutes, then switch the car on in order to the system back into action.

If it is discovered that the traction control system of your vehicle has to be replaced it is important to be aware about the cost. A replacement for the this switch can range from between $80 and$95. The labor cost could run the range of $40 to$50. The part, however, is priced between $40 and$45.

The cost of wheel sensors is $100 to$200 however, you could think that they will be priced between $200 and$600. Remember that the Services Stabiltrak Chevrolet Cruze charges are only an estimates, and they could vary based on your vehicle's model and the year.

Also Read: resonator delete

How The Stabilitrak System Works

Stabilitrak utilizes a sophisticated set of sensors to determine whether you Chevy Cruze is appropriately responding to your input during emergencies.

StabiliTrak: Main Components

Wheel speed sensors - They determine the speed at which each wheel turns. There's one for each hub.

Rotation rate sensor - Measures the speed of rotation and lateral acceleration in the direction of the centerline.

Sensor for steering wheel position- It measures how many degrees the steering wheel has turned.

Control Unit- Utilizes the information taken from three of the sensors mentioned above and decides when to turn on the StabiliTrak system. It could also inform to the Powertrain Control Module that it is time to cut the engine's power when needed.

Hydraulic Systemcan activate only one brake at the same time. It is usually a piggyback off from the ABS.

Also Read: Magneto Ignition System

How It Uses These Components

The StabiliTrak control unit utilizes information from its sensors to apply an appropriate brake or decrease the engine's power to stop the slide and help get your Cruze to point in the correct direction.

For instance, if the Cruze is sliding across frozen ice, StabiliTrak can apply one of the rear brakes to steer you towards the correct direction. Here's a video by GM which explains exactly how the system operates.

Also Read: Carrier AC Unit Not Cooling